DME 7.8 DME 7.8 0 · 0-38.10P0230

DME 7.8 DME 7.8 0 0-38.10P0230 Fuel Pump Relay Output Stage – Open Circuit Diagnosis conditions • Engine started Note! The triggering wire for the fuel pump relay, terminal 85, is moni- tored. Possible fault cause ♦Fuel pump relay ♦Open circuit ♦DME control module Affected terminals Terminal IV/10 Diagnosis/Troubleshooting Work instruction Display OK If not OK 1 Check fuel pump relay ♦Remove fuel pump relay Approx. 75 Ω Replace fuel pump ♦Measure resistance between Pin Step 2 relay → End 85 and Pin 86 2 Check wiring from DME ♦Connect special tool 9637 to 0 - 5 Ω Check plug connec- control module, Pin IV/10, wiring harness (DME control Step 3. tion X 2/3 and wir- to fuel pump relay for con- module plug). ing harness tinuity → End ♦Remove fuel pump relay ♦Measure resistance between special tool 9637, Pin IV/10, and fuel pump relay slot, Pin 6 (terminal 85) 3 Replace DME control module. Step 4. 4 Perform adaptation. ♦Switch on the ignition. → End. ♦Wait one minute. ♦Do not press the accelerator. ♦Switch off the ignition for at least 10 seconds. ♦Read out the fault memory. 2472 P0230 0-38.10 page 1 Printed in Germany – 6, 2002 p0230