Porsche DME 7.8 — OBD II Diagnosis Manual / PAGE 491
DME 7.8 DME 7.8 0 · 0-54.1P0336
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
DME 7.8 DME 7.8 0
0-54.1P0336
Crankshaft Position Sensor, Signal Implausible
Diagnosis conditions
• Engine running
Possible fault cause
♦Corrosion in the connector
♦Loose contact
Affected terminals
III/32, III/45 and III/46
Diagnosis/Troubleshooting
Work instruction Display OK If not OK
1 Remove connector.
2 Check connector for cor- ♦Visual inspection. Clean contacts.
rosion.
3 Check rpm/crankshaft ♦Measure resistance between 0.8 - 1.0 kΩ at 20 Replace rpm/crank-
position sensor. pins 1 and 2. °C. shaft position sen-
sor.
♦Measure resistance between ∞ Ω
pins 1 and 3.
4 Check signal with engine ♦Connect special tool 9637. The following dis-
tester. ♦Connect engine tester. Use spe- play should appear
on the oscilloscope. cial input, connect positive cable
to pin III/32, negative cable to
pin III/46
♦Start engine or crank engine
with starter motor.
2873 P0336 0-54.1 page 1
Printed in Germany – 6, 2002 p0336a
This is a source reference. Confirm exact model applicability in the original material.