DME 7.8 DME 7.8 0 · 0-56P0342

DME 7.8 DME 7.8 0 0-56P0342 112 Camshaft position sensor 1 - below limit Diagnosis conditions • Engine running Possible fault cause ♦Short circuit to ground Note! ♦If both CMP sensor signals are missing, the start will take at least 10 seconds. ♦For safety reasons, the ignition timing is retarded. Affected terminals Terminal III/12 Diagnosis/troubleshooting Work instruction Display OK If not OK 1 Check signal wire from ♦Connect special tool 9637 to ∞ Ω Repair wiring har- DME control module, wiring harness (DME control → End ness Pin III/12, to CMP sensor module plug) → End for short to ground ♦Remove connector of CMP sen- sor 1 ♦Measure resistance between special tool 9637 Pin III/12 and ground 2839 P0342 0-56 page 1 Printed in Germany, 2000 p0342