DME 7.8 DME 7.8 0 · 0-57.2P0347

DME 7.8 DME 7.8 0 0-57.2P0347 Camshaft Position Sensor 2 – Below Limit Diagnosis conditions • Engine running Possible fault cause ♦Short circuit to ground Note! ♦If both CMP sensor signals are missing, the start will take at least 10 seconds. ♦For safety reasons, the ignition timing is retarded. Affected terminals Terminal III/18 Diagnosis/Troubleshooting Work instruction Display OK If not OK 1 Check signal wire from ♦Connect special tool 9637 to ∞ Ω Repair wiring har- DME control module, wiring harness (DME control → End. ness Pin III/18, to CMP sensor module plug). → End. for short to ground ♦Remove connector of CMP sen- sor 2 ♦Measure resistance between special tool 9637 pin III/18 and ground. 2839 P0347 0-57.2 page 1 Printed in Germany – 6, 2002 p0347