DME 7.8 DME 7.8 0 · 0-95P0712

DME 7.8 DME 7.8 0 0-95P0712 Transmission Oil Temperature - Below Limit Diagnosis conditions • Idle speed Possible fault cause ♦Temperature sensor faulty ♦Wiring harness ♦DME control module faulty Affected terminals Terminal II/23 and IV/11 Resistance values 60 2.8 -3.5 kΩ °C 90 1.0 -1.3 kΩ °C 120 0.4 -0.6 kΩ °C Diagnosis/Troubleshooting Work instruction Display OK If not OK 1 Check temperature sen- ♦Connect special tool 9637 to 2.8 - 3.5 kΩ Replace tempera- sor wiring harness (DME control (at 60 °C) ture sensor module plug). Step 2 → End ♦Measure resistance between Pin II/23 and Pin IV/11 2 Check wiring from DME ♦Connect special tool 9637 to 0 - 5 Ω Note control module to temper- wiring harness (DME control Step 3. The lines are routed ature sensor for continu- module plug). via the transmis- ity ♦Remove plug connection of tem- sion plug connec- tion perature sensor Repair wiring har- ♦Measure resistance between ness special tool 9637 Pin II/23 and → End temperature sensor plug Pin 2 ♦Measure resistance between special tool 9637 Pin IV/11 and temperature sensor plug Pin 1 3478 P0712 0-95 page 1 Printed in Germany – 6, 2002 p0712