Porsche DME 7.8 — OBD II Diagnosis Manual / PAGE 714
DME 7.8 DME 7.80 · Figure 1:
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
DME 7.8 DME 7.80
Figure 1:
Figure 2:
Work instruction Display OK If not OK
2 Check TP voltage supply. ♦Connect special tool 9637 to Approx. 5 V
wiring harness (DME control
module plug).
♦Measure voltage between Pin III/
10 and Pin III/25
♦Switch on the ignition.
3 Check voltage values of ♦Connect special tool 9637.
throttle position sensors. ♦Switch on the ignition.
♦Measure voltage between Pin III/ Approx. 0.7 -0.9 V Replace throttle part
24 and Pin III/25
♦Fully depress accelerator pedal Approx. 4.1 -4.5 V
♦Measure voltage between Pin III/ Approx. 4.0 -4.4 V
8 and Pin III/25
♦Fully depress accelerator pedal Approx. 0.5 - 0.8 V
4 Check wiring from throttle ♦Separate disconnection point to
part to DME control mod- throttle part
ule for continuity or short ♦Connect special tool 9637 to
circuit to B+ and ground wiring harness (DME control
module plug).
0-109.1 page 2 2442 P1120
p1120 Printed in Germany – 6, 2002
This is a source reference. Confirm exact model applicability in the original material.