DME 7.8 DME 7.80 · Figure 1:

DME 7.8 DME 7.80 Figure 1: Figure 2: Work instruction Display OK If not OK 2 Check TP sensor voltage ♦Connect special tool 9637 to Approx. 5 V ⇒ Step 4 supply wiring harness (DME control ⇒ Step 3 module plug) ♦Switch on the ignition ♦Measure voltage between Pin III/ 10 and Pin III/25 3 Check voltage values of ♦Connect special tool 9637 Replace throttle part throttle position sensor 2 ⇒ Step 6 ♦Switch on the ignition ♦Measure voltage between Pin III/ Approx. 4.0 - 4.4 V 8 and Pin III/25 ♦Fully depress accelerator pedal ♦Measure voltage between Pin III/ Approx. 0.5 - 0.8 V 8 and Pin III/25 4 Check wiring from throttle ♦Separate disconnection point to Repair wiring har- part to DME control mod- throttle part. ness ule for continuity or short → End ♦Connect special tool 9637 to circuit to B+ and ground wiring harness (DME control module plug) 0-111 page 2 2442 P1122 p1122 Printed in Germany, 2000