Porsche DME 7.8 — OBD II Diagnosis Manual / PAGE 881
DME 7.8 DME 7.8 0 · 0-153P1343
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
DME 7.8 DME 7.8 0
0-153P1343
149 Camshaft Adjustment, Bank 2 Output Stage -
Open Circuit
Diagnosis conditions
• Engine running
Possible fault cause
♦Open circuit in triggering wire
♦Open circuit in B+ supply
♦Solenoid hydraulic valve faulty
Affected terminals
V/8
Diagnosis/Troubleshooting
Note!
The wiring for the solenoid hydraulic valve is routed via the connector X 59/1 pin 15
Work instruction Display OK If not OK
1 Check triggering wire for ♦Connect special tool 9637 to 0 - 5 Ω
continuity wiring harness (DME control
module plug)
♦Remove connector of the sole-
noid hydraulic valve
♦Measure resistance between V/
8 and solenoid hydraulic valve
connector pin 2.
2 Check B+ supply for sole- ♦Remove connector of the sole- Battery positive volt-
noid hydraulic valve noid hydraulic valve age
♦Switch on the ignition
♦Measure voltage of solenoid
hydraulic valve connector pin 1
and ground
3 Check resistance of sole- ♦Measure resistance of solenoid 8 - 12 Ω at 20° C
noid hydraulic valve hydraulic valve between pin 1
and 2
1536 P1343 0-153 page 1
Printed in Germany – 2, 2000 p1343
This is a source reference. Confirm exact model applicability in the original material.