DME 7.8 DME 7.8 0 · 0-156P1350

DME 7.8 DME 7.8 0 0-156P1350 637 Valve lift control checksum error - above limit Diagnosis conditions • Speed between 5,280 and 6,520 rpm • Load between 125 and 190 % • Acceleration with wide-open throttle Possible fault cause ♦A valve does not switch to large lift ♦Several valves (various cylinders) do not switch to large lift Affected terminals - Diagnosis/troubleshooting Perform system test for large lift Warning! During the system test for large lift, the valves remain at large lift, regardless of the type of driving. Faulty switching conditions can be detected by rough running, just like with misfire detection. If a valve is not switched to large lift, the fault type ’over limit’ is recorded. Several cylinders may be stored as faulty, although only 1 valve on one cylinder is faulty. In order to guarantee safety during repairs, the flat-base tappets of the inlet valves of the entire cylinder bank should be replaced if a fault occurs. A faulty flat-base tappet can be detected because the oxygen sen- sor FR for this cylinder bank does not change the mixture at all given acceleration with wide-open throttle (FR at 1) and enriches the mix- ture in the opposite cylinder bank (FR > 1)⇒ see drawing below. Given a difference between FR1 and FR2 of more than 8 %, a fault is certainly present. 1555 P1350 0-156 page 1 Printed in Germany, 2000 p1350