YOUR RESEARCHCDR 220 Wiring Question - SEARCHED!! - 986 Forum - The Community for Porsche Boxster & Cayman Owners
1 matching discussions were examined; no attributable action/outcome evidence was detected. No consensus or repair conclusion is claimed.
Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.
Read captured repliesInsufficient extracted evidence does not mean there is no answer in the original discussions.
1 matching discussions · 5 captured posts examined · 0 partial discussions
Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.
5 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.
0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.
0 acknowledgements have no verified action link; they do not establish a repair result.
Generation: 20261027T003124Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources
Guys I am requesting your help! I have searched every forum, every thread, and every google hit I could possible type to try and figure out what the single wire with a rubber coated female spade connector is for that connects to the back left (if you are looking at the faceplate) side of the CDR 220. If it helps it comes out of the harness that goes to the variable wiper knob. What is this for???? What does it do???
What does the connector on the radio look like? An actual spade connector or just a tab?
Quotes source post: 418356
I wish I could find a picture of it. It is just a tab that seems to be built into the case housing near the fuses on the lower right corner (if you were looking at the back)
With the radio out look inside the housing where the radio slides into.On the left side of the metal case there is a male spade connector where the wire plugs onto.When the radio is slid in that becomes the chassis ground for the radio,at least that is the way my CR 220 is.
Sounds like the alarm wire for the radio.
This is a source reference. Confirm exact model applicability in the original material.
