YOUR RESEARCHSpyder Number Plates - Page 1 - Boxster/Cayman - PistonHeads UK
1 matching discussions were examined; no attributable action/outcome evidence was detected. No consensus or repair conclusion is claimed.
Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.
Read captured repliesInsufficient extracted evidence does not mean there is no answer in the original discussions.
1 matching discussions · 4 captured posts examined · 1 partial discussions
Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.
4 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.
0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.
0 acknowledgements have no verified action link; they do not establish a repair result.
Generation: 20261026T174436Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources
I am about to fit replacement number plates to my 718 Spyder and have noticed that the Standard fixing positions have the screws at the ends of the front plate but nearer the centre of the rear plate ........... noticeable on all the official Spyder rear pics . Does anyone know the reason for this ? I may wish to bring the rear plate screws towards the ends to match the front plate but do not wish to cause any internal screw damage .
The screws will be through the rear bumper - so by moving the screws for aesthetics you're going to be making more holes. The rear bumper has a slightly raised section in the middle - looks like to accommodate a US sized plate - if you put the screws outside of this the middle of the plate might bow a little around it. The front is obviously screwed at the end because of the curve of the front bumper.
never screw on any plates I always us good quality double edge tape ,as to the curve on the front gently bend it and apply heat i made up jig and leave on a radiator for 24hrs it gives a nice curve and does not spring away at the corners when taped down.
Are stickers ok?
This is a source reference. Confirm exact model applicability in the original material.
