YOUR RESEARCHrear subframe question
1 matching discussions were examined; no attributable action/outcome evidence was detected. No consensus or repair conclusion is claimed.
Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.
Read captured repliesInsufficient extracted evidence does not mean there is no answer in the original discussions.
1 matching discussions · 4 captured posts examined · 0 partial discussions
Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.
4 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.
0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.
0 acknowledgements have no verified action link; they do not establish a repair result.
Generation: 20261027T175704Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources
I am currently building a awd splitscreen camper using a 911 motor, 964 trans and diff and 996 rear suspension. As I have no datum point with which to ensure subframes are square to each other I am hoping someone could tell me the centre (nearside mounting point) to centre (offside mounting point) dimensions of the 3 mounting points for the sub frame to chassis?
Can you sketch this? I have the engine out but I don't understand what point exactly points you need dimensions for.
Sounds like a cool project. Have you created a front cage to protect your legs in a fender bender? I ask this because I've looked at the foot well protection of these older models and shook my head at what VW 'thought' was front end protection even with a vehicle that had only 45hp - not the over 300hp your installing.
Quotes source post: 9818423
Hi, i hope this picture helps, i am after the distance between the chassis fixing point for A and the chassis fixing point for B as shown in the diagram. To get the sub frames square i need the similar distances for the other 2 fixing fixing points. Once i have these it will give me a ratio of the dimensions which i can apply to my own chassis. hope that is clear as mud?
This is a source reference. Confirm exact model applicability in the original material.
