fullymatted.
Back to search
Rennlist

H&R spring install question

Add to repair workspace
Open repair workspace
Original source
4 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis
THIS DISCUSSION / SOURCE-DERIVED OVERVIEW

Discussion summary

YOUR RESEARCHH&R spring install question

1 matching discussions were examined; no attributable action/outcome evidence was detected. No consensus or repair conclusion is claimed.

Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.

Read captured replies

Insufficient extracted evidence does not mean there is no answer in the original discussions.

1 matching discussions · 4 captured posts examined · 0 partial discussions

Coverage and how to read this overview

Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.

4 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.

  • Rennlist: 1 discussions

0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.

0 acknowledgements have no verified action link; they do not establish a repair result.

Generation: 20261026T152433Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources

POST 1 / ORIGINAL POSTEROriginal post

I'm installing H&R sport springs on my '00 C2 coupe (part 29513--I've tripled checked that I have the correct springs). On the H&R technical sheet, they say to trim the front bump stop for the following application (which is closest to mine): "part #29813, Porsche C2, C4". The technical sheet on their website says the same. My question is: do I trim the bump stop assuming this applies to my application? Or not? For those of you who installed these, did you have to trim the front bump stops? (H&R says no need to on the rears for the referenced application.) I may just have to wait and call them tomorrow. Thanks

POST 2 / ORIGINAL POSTEROriginal post

On a hunch, I searched H&R's website for springs for a '92 C2 and the part is 29813. So I'm going to assume that my application (#29513) does not require trimming the bump stops. Please correct me if I'm wrong.

This is a source reference. Confirm exact model applicability in the original material.