POST 1 / ORIGINAL POSTEROriginal post
The rear of my sunroof is about 1/8 inch low, is there a way to bring it up snug? thanks much... rick
2 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis
Discussion summary
YOUR RESEARCHsunroof adjustment??
1 matching discussions were examined; no attributable action/outcome evidence was detected. No consensus or repair conclusion is claimed.
Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.
Read captured repliesInsufficient extracted evidence does not mean there is no answer in the original discussions.
1 matching discussions · 2 captured posts examined · 0 partial discussions
Coverage and how to read this overview
Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.
2 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.
- Rennlist: 1 discussions
0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.
0 acknowledgements have no verified action link; they do not establish a repair result.
Generation: 20261026T120458Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources
POST 2Original post
Hi Open the roof about 80mm and push the trim panel back off its two clips at the front by about 30mm. Then tilt the roof and push the trim back as far as you can...It's quite fragile and there is a water drain at the back..go steady! There are 4 torx screws holding the panel to the side runners, there is about 8mm of adjustment available..sorry for being all european and metric! It should sit with front either flush or -1mm and rear flush or +1mm. Hope this helps.
This is a source reference. Confirm exact model applicability in the original material.