Porsche Club GB

Chassis dimensions required

Add to repair workspace

2 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis

THIS DISCUSSION / SOURCE-DERIVED OVERVIEW

Discussion summary

YOUR RESEARCHChassis dimensions required

1 matching discussions were examined; no attributable action/outcome evidence was detected. No consensus or repair conclusion is claimed.

Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.

Read captured replies

Insufficient extracted evidence does not mean there is no answer in the original discussions.

1 matching discussions · 2 captured posts examined · 0 partial discussions

Coverage and how to read this overview

Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.

2 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.

Porsche Club GB: 1 discussions

0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.

0 acknowledgements have no verified action link; they do not establish a repair result.

Generation: 20261026T144035Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources

POST 1 / ORIGINAL POSTEROriginal post

I am currently building a awd splitscreen camper using a 911 motor, 964 trans and diff and 996 rear suspension. As I have no datum point with which to ensure subframes are square to each other I am hoping someone could tell me the centre (nearside mounting point) to centre (offside mounting point) dimensions of the 3 mounting points for the sub frame to chassis? I am after the distance between the chassis fixing point for A and the chassis fixing point for B as shown in the diagram. To get the sub frames square i need the similar distances for the other 2 fixing fixing points. Once i have these it will give me a ratio of the dimensions which i can apply to my own chassis. hope that is clear as mud

POST 2Original post

Drop me an email and I'll see what I can extract from the workshop manual for you.

This is a source reference. Confirm exact model applicability in the original material.