Page 2
Installing Knock Sensor, Cylinder Bank 4 -6
1. Clean contact surface for the sensor on the engine block.
CAUTION:
The precise tightening torque for the knock-sensor screw must be observed, otherwise the knock sensor might not function properly.
2. Put on the knock sensor, then screw in and tighten the M8 hexagon-head bolt
-upper arrow-
.
3. Reconnect plug of the knock sensor
-lower arrow-
.
Tightening torque
23 Nm (17 ftlb.)
4. Install the oil container.
This is a source reference. Confirm exact model applicability in the original material.