Page 1
Shifter A/T: Service and Repair
Selector Knob
Removing and installing selector knob
Removal
1. Lever off locking button with an angled pipe. The locking button must be pressed so that the pipe section can be inserted between the shift lever
and the locking button. To do this, turn the ignition key to "1" position.
2. Remove the compression spring and spring clip and pull off the selector knob.
Installation
1. Assemble the selector knob with spring clip, compression spring and locking button.
Note:
Fit conical compression spring with the small diameter facing the guide peg.
2. Press the complete selector knob onto the shift lever until it bottoms.
3. Check the function of the locking button.
This is a source reference. Confirm exact model applicability in the original material.