Page 2
Selector support components
Removal
1. Remove selector knob.
2. Remove center console.
3. Move selector lever to position "D".
4. Disengage keylock cable:
-
Open adjuster (3) by pressing the unlocking button (7).
-
Press the retaining clip (4) together and carefully pull the adjuster (3) upward out of the support bracket.
-
Disengage cable nipple (1) on the keylock lever (2).
5. Disengaging selector lever cable:
-
Slide the locking sleeve of the adjuster forward and turn it clockwise to removal position (8).
-
Press the retaining clip (10) together and carefully pull the cable upward out of the support bracket.
6. Disconnect plug connection.
7. Unscrew fastening nuts (11).
Installation
Install in reverse order, observing the following points:
1. Tighten fastening nuts (11) to
10 Nm (7.5 ft. lbs.)
.
2. Fastening selector lever cable:
-
Press the cable into the support bracket until the retaining clip engages in the housing (10).
-
Press cable into the open adjuster (8) and close the adjuster (9). The locking sleeve must move to the end position automatically (9).
3. Fastening keylock cable:
This is a source reference. Confirm exact model applicability in the original material.