Page 7
5. Pull out sealing ring by screwing in the hexagon-head screw.
Note:
The coil spring must be pulled off the input shaft with a wire hook if the spring should jump down when removing the sealing ring.
Installation
1. Push assembly sleeve 9255 onto the toothing of the input shaft.
2. Fill the space between the dust and sealing lips on the sealing ring with grease (e.g. Liqui Moly).
3. Drive in sealing ring with special tool 9628 as far as the mounting face.
4. Install guide tube for release bearing. Always renew fastening screws and tighten with
24 Nm (18 ft. lbs.)
5. Fit release lever with release bearing.
6. Clean teeth of the input shaft and grease with a thin coat of Olista Longtime 3 EP (available as spare part).
This is a source reference. Confirm exact model applicability in the original material.