Workshop ManualsOriginal source
Removing and Installing Shift and Selector Cables|Page 3790
Add to repair workspace
Page 3
Installation
1. Insert the closure cap and snap ring into the hole in the housing.
2. Using special tool P375 press the snap ring and closure cap down until the snap ring engages into its groove.
Information
-
Ensure that the snap ring is perfectly secure.
3. Tighten the fastening screw for the wheel bearing housing to 25 Nm (19 ftlb.) .
4. Install the transmission.
This is a source reference. Confirm exact model applicability in the original material.