Page 1
Brake Master Cylinder: Service and Repair
Removing and installing brake master cylinder
Removal
Note!
The booster pump - arrow - remains fitted (installed) during removal and installation of the brake master cylinder in vehicles with PSM.
1. Remove cover - A - from the hydraulic unit/brake unit.
2. Remove brake fluid from reservoir using suction.
3. Remove suction line -2- of booster pump -1- in vehicles with PSM.
4. For vehicles with manual transmission, remove the clutch line at the reservoir.
-
Press on the ring to do this (unlocking) and pull the line out of the reservoir at the same time.
5. Disconnect the electrical line (plug) on the reservoir.
6. Undo the brake lines on the brake master cylinder. Close the brake lines and the brake line connections with suitable plugs.
This is a source reference. Confirm exact model applicability in the original material.