Page 5
4. Mount intermediate piece -11- (2 M8 nuts and hexagon socket head bolt). Tightening torque of the 2 M8 nuts =
23 Nm (17 ft. lbs.)
.
5. Install battery.
6. Install new pushrod (if not already present) -12.1- in place of -12-. When doing so, observe installation dimension X
(138 mm)
.
Basic setting of the push rod -dimension X- is
138 mm
(set in new brake boosters)! If necessary, correct during the relevant work!
7. Install brake booster and brake master cylinder with mounted bellows -B- and tightened clamps -6-.
Note!
Before using the brake booster, push the screw clamp -6.1- onto the bellows -B- or onto the brake pushrod!
This is a source reference. Confirm exact model applicability in the original material.