Page 6
8. Tighten fastening screws of brake booster (Torx T 45) -arrow- to
23 Nm (17 ft. lbs.)
. Fit the vacuum line for the brake booster.
-
If the brake master cylinder has been removed, tighten the fastening nuts (M14) to
49 Nm (36 ft. lbs.)
.
9. Connect the 2 push rods. To do so, mount the fastening nuts -arrow-
Note!
-
Adjusting the brake pushrod length changes the position of the brake pedal.
-
Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given!
-
After the brake pushrod is adjusted, check the brake light switch adjustment!
10. Check the position of the brake pedal
-Dimension X = 45 + 5 mm-
Perform measurement between the center of the brake pedal plate and the
accelerator. Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given.
-
Precise adjustment of brake pushrods: Undo the lock nut for this purpose and the turn the push rod accordingly at the hexagon -arrow- until
-dimension X = 45 + 5 mm-
has been achieved. Subsequently re-tighten the lock nut.
This is a source reference. Confirm exact model applicability in the original material.