Page 6
Note!
Do not trap wiring harness!
2. Tighten fastening screws (Torx T 45) -arrow- to
23 Nm (17 ft. lbs.)
.
3. Connect the 2 push rods. For this purpose, fit the retainer or fastening nut (standard fastening nut as of April 2001) -arrow-.
Note!
-
Adjusting the brake pushrod length changes the position of the brake pedal!
-
Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given!
-
After the brake pushrod is adjusted, check the brake light switch adjustment!
4. Check the position of the brake pedal
-Dimension X = 45 + 5 mm-
Perform measurement between the center of the brake pedal plate and the
accelerator. Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given.
-
Precise adjustment of brake pushrods: Undo the lock nut for this purpose and the turn the push rod accordingly at the hexagon -arrow- until
-dimension X = 45 + 5 mm-
has been achieved. Subsequently re-tighten the lock nut.
5. Fit the bellows onto the body or onto the connection sleeve and fasten with the clamps.
This is a source reference. Confirm exact model applicability in the original material.