Page 4
-
Heat wheel bearing housing to approximately
100°C (max. 120°C)
. Press out wheel bearing with tubular piece VW 415 A (tool C).
-
Press inner wheel bearing race off the wheel hub.
To do this, use pressure piece P 297 A (tool A) in combination with the separator (tool B).
Note:
First pull the inner bearing race several millimeters off the wheel hub so that the separator can be put into place. For this purpose, use a
two-claw puller in combination with a suitable pressure piece (e.g. VW 433).
Installation
-
Before installation, clean the bore in the wheel bearing housing and remove any surface irregularities with a polishing cloth.
-
Heat wheel bearing housing to
approximately 100°C (max. 120°C)
. Insert new wheel bearing, and then press again slightly using pressure piece
9247/4 (tool D) and tubular piece VW 415 A (tool C).
This is a source reference. Confirm exact model applicability in the original material.