Page 227
-
Good and fast sanding properties
Base surfaces:
Soft plastics:
-
PUR
-
Polyurethane integral foam (soft)
Hard plastics:
-
PUR Polyurethane RIM/R-RIM
-
PP/EPDM Polypropylene/ethylene-propylene-diene monomer
-
ABS Acryl-butadien-styrene
-
GFK Glass fiber-reinforced plastic
-
GF-UP Glass fiber-reinforced polyester
-
SMC Sheet Molding Compound
-
BMC Bulk Molding Compound
-
PVC Hard polyvinyl chloride
-
PC Polycarbonate
-
PA Polyamide
-
PBTP Polybutylene terephtalate
-
PPO Polyphenylene oxide (Noryl)
Non-paintable:
-
PP/PE Polypropylene/polyethylene
-
PVC Soft polyvinyl chloride
NOTE:
-
Bake PUR foam and PA (1h/60° C) to remove parting agents or water completely from the pores, then clean thoroughly with Glasurit(R) Universal
Cleaner for Plastics 541-30
-
The material must be cleaned thoroughly with Glasurit(R) Universal Cleaner for Plastics 541-30
VOC value:
-
> 420 g/l
G 9.4.2.1 Processing
See: Section G9/G9.5 - GF - Primer Surfacer
G9.5 - GF - Primer Surfacer
G 9.5 GF - Primer Surfacer
G 9.5.1 Glasurit(R) 1C Primer Filler 76-71
G 9.5.1.1 Processing
G 9.5.2 Glasurit(R) Etch Primer Filler 283-150
G 9.5.2.1 Application as a primer
This is a source reference. Confirm exact model applicability in the original material.