Page 376
-
Good insulator
Base surfaces:
-
Hardened paintwork, sanded
-
Polyester products, sanded
-
Cleaned sheet steel, sanded
-
Factory primer and KTL, sanded
-
Aluminum and galvanized base surfaces
-
Fiber-reinforced plastic
-
Please note base surface pre-treatment instructions:
-> S 5.1
-> S 6.1
-> S 9.2.2
NOTE:
-
Raw material base: Epoxy resin, corrosion inhibition pigments
-
Flash point: 28° C/82.4° F
-
Spec. weight: 1.6 g/cm3
-
Solid content: 73.8% weight/52.4% vol.
-
Theoretical yield: 5.6 m2/ltr. with a dry coat thickness of 75 microns
-
Clean equipment with cleaning thinner
VOC value:
-
420 g/l
NOTE:
-
Do not use Standox(R) EP Primer Surfacer on acid primer.
S 9.5.4.1 Application as a wet-on-wet filler
S 9.5.4.2 Working with sanding filler
This is a source reference. Confirm exact model applicability in the original material.