Page 5
11
-
Removing convertible-top covering at the corner bow
1. Undo the bond of the inner cloth covering
-inset A-
around the corner bow.
2. Fold the convertible-top covering forwards to the roof frame.
3. Pull seal
-arrow B-
out of the groove of the corner bow and disengage the covering strip of the convertible-top covering in downward
direction.
12
-
Removing convertible-top covering at the main bow
1. Pull the tightening strip of the convertible-top covering
-16-
from the groove of the main bow
-17-
. Remove convertible-top covering from
the vehicle.
Installing the convertible-top covering
CAUTION:
-
Damage (tearing) to the zip fastener connection on the convertible-top covering!
-
The adhesion (hot-melt process) between the rear window and the convertible-top covering must be implemented before the first
closure or calibration of the convertible top.
-
All pins and screw joints must be checked for tightness before the convertible-top covering is installed. Refer to "Assembling
convertible-top frame".
-
The tension strap must be replaced before fitting the convertible-top covering. Refer to "Installing tension strap".
1
-
Fastening convertible-top covering at the main bow
-
Lay the convertible-top covering on the convertible-top frame, fit the front tightening strip
-16-
of the convertible- top covering in the
groove of the main bow
-17-
and centre.
2
-
Fitting convertible-top covering at the corner bow
1. Press tightening strip centre (notch marking) into groove of the corner bow (centre of the corner bow is identified by a hole).
This is a source reference. Confirm exact model applicability in the original material.