Page 7
5
-
Fastening the convertible-top covering at the sides of the roof frame 1
1. Lay the convertible-top covering to the front and guide the shaped sheetmetal part
-14-
into the roof frame
-15-
from above.
2. Fasten the convertible-top covering with the fastening screws
-13-
starting from the rear bottom side of the roof frame.
Tightening torque
5 Nm (4.0 ftlb.)
6
-
Fastening convertible-top covering at front
A cardboard strip and a self-adhesive strip are affixed at the front of the convertible-top covering.
1. Pull the protective film off the Teflon adhesive tape.
2. Fold the convertible-top material around the roof frame edge without wrinkles. The convertible-top covering is initially held with fixing
clips.
7
-
Fastening the retaining rail and convertible-top seal on the roof frame 1
1. Remove the fixing clips.
2. Insert convertible top seal
-12-
at the front corners into roof frame 1 in
-direction of arrow-
and tighten with torx screws T25
-11-
.
Tightening torque:
1.7 Nm (1.0 ftlb.)
1. Position the retaining rail
-10-
on roof frame 1 and tighten using T25 Torx screws
-9-
.
Tightening torque:
3.5 Nm (2.5 ftlb.)
This is a source reference. Confirm exact model applicability in the original material.