Page 9
11
-
Fitting tension bow seal
1. Press tension bow seal into the lower groove of the tension bow and fasten at both ends with the T25 Torx screws
-2-
.
Tightening torque:
5 Nm (3.5 ftlb.).
12
-
Fastening pull strap at the main bow
1. Pull the restraining strap through the fabric pocket on the main bow.
2. Engage both ends of the restraining straps into the tension spring
-arrow A-
.
3. Position fabric pocket on the main bow and fasten with the T 10
-1-
Torx screws.
13
-
Inserting flexible rear window
1. Refer to Removing and installing flexible rear window of Cabriolet
CAUTION: Damage (tearing) to the zip fastener connection on the convertible-top covering!
-
The adhesion (hot-melt process) between the rear window and the convertible-top covering must be implemented before the first closure
or calibration of the convertible top.
1. End service position.
2. Calibrate the convertible top. To do this, connect the Porsche System Tester 2 to the diagnostic socket. Switch on ignition to carry out this test.
Select menu item "Convertible top", and select menu item "Calibrate" in the command line which then appears. Start calibration with the [F7] key.
Calibration can be started irrespective of whether the convertible top position is open or closed. The latching hook in roof frame 1 does not close
during calibration.
NOTE:
-
If the convertible-top covering is very taut (with new convertible- top covering), close the convertible top and heat the convertible- top covering
evenly using an infra-red radiator.
This is a source reference. Confirm exact model applicability in the original material.