Page 8
9
-
Fastening tension cable of the convertible-top covering
-
Position the tension cable eyelet
-3-
on the main bow and fasten with the T25
-4-
Torx screw.
Tightening torque:
7 Nm (5.0 ftlb.)
10
-
Fastening convertible-top covering on the tension bow
NOTE:
Cutouts have been integrated to the right and left of the additional seal.
1. Integrate the additional seal parallel to the tension strap
-C-
into the cutouts on the right and left using a knife.
2. Press tightening strip centre (notch marking)
-inset A-
into the lower groove of the tension bow
-inset B-
(centre of the tension bow is
identified by a hole)
-inset A-
.
3. The reference overlap seams of the convertible-top covering must be positioned and centered in the additional seal
-arrow C-
cutouts on
the left and right.
4. Secure the convertible-top covering by tapping in the seal
-inset D-
.
11
-
Fitting tension bow seal
1. Press tension bow seal into the lower groove of the tension bow and fasten at both ends with the T25 Torx screws
-2-
.
Tightening torque:
5 Nm (3.5 ftlb.)
.
This is a source reference. Confirm exact model applicability in the original material.