Page 4
No. 6 - 9
Adjusting the gap dimensions of the rear side section trim
Measurement Locations
Adjusting gap dimensions
(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The adjustment,
Figure C
, is made by means of the Torx
screws in the flap.
Dimension A = 4.0 + 2.0 mm
gap width between the rear side section trim and side section trim.
Dimension B = 3.0 + 2.0 mm
gap width between the roll-over protection system cover and rear side section trim.
This is a source reference. Confirm exact model applicability in the original material.