Page 6
3.2
Bond the rear upper side of the panel to roof frame 1 using a felt strip, approximately 25 mm wide placing it along the entire width of the panel
Item 8.2, Figure 11). The felt strip must be flush with the rear edge.
3.3
On the upper side of the panel, cover the cut out for the convertible-top lock (Item 8.3, figure 11). Use the backing from the felt that is provided
with the new panel.
3.4
Apply felt over the entire upper side of roof frame 1 and the panel. The felt film is enclosed with the new panel. Pull the Figure 11 protective
backing off the adhesive side of the felt. With the help of a second person, affix the felt crease free from the rear edge of roof frame 1 over the
attached felt strip on the upper side of the panel and the roof frame 1 (item 8.4, figure 12). The overlapping felt at the front edge should be cut off
flush with a pair of scissors or a sharp knife.
3.5
Install the front centering pegs. Torque the T30 Torx bolts to 7Nm (5 ft-lb.).
This is a source reference. Confirm exact model applicability in the original material.