Page 3
5. Undo ground strap between engine and body. Undo the strap at the engine (cylinder head, near cylinder 6).
Checking camshafts of cylinder bank 1 - 3
1. Move camshafts of cylinder bank 1 - 3 to basic position. Turn crankshaft clockwise until the bore 1 OT (top dead center) in the belt pulley is
aligned with the fixing bore on the crankcase. Position or fix with fixing pin (short) of special tool 9595 or 9595/1.
2. Check basic camshaft adjustment of cylinder bank 1 -3 . Ensure that the groove in the camshaft faces outward toward the cylinder head cover.
View from the f~wheel side
If the position of the camshafts is incorrect or the groove in the inlet camshaft does not face outward, remove fixing pin of belt pulley and turn
crankshaft a further 360° clockwise. Then position or fix the fixing pin in the bore (1 OT) and the fixing bore in the crankcase again.
3. Check the position of the groove again.
This is a source reference. Confirm exact model applicability in the original material.