Note 2. Next, perform the horizontal adjustmentof · the dipped beam headlights

911 Carrera (996) Maintenance Note 2. Next, perform the horizontal adjustmentof the dipped beam headlights.To do this, line Make the adjustmentwith the regulator switch up the left, horizontal part of the light/dark set to O. (Headlightbeam adjustment). limit (in the case of driving on the right) with the dotted horizontal line of the adjustment unit. With this alignment,preference must be given to the central zone around the salient point of the lighVdark limit. b A -Lateral adjustment 8_'_96 .'."".', B -Height and side adjustment C -Fog light adjustment ~:i:2;~1£i~:i::::;i:..~. - L .J Use a standard 5 mm ball-headscrewdriver to make the headlight adjustment. Onlythe lower screw may be turned for height adjustment;for 290_96 lateral adjustmentthe upper and lower screws must be turned in the same direction and for Note the same number of rotations. The distance between the headlights and the adjustment unit should be as small as possible. It should not exceed 30 cm, because if the distance is greater, it is no longer possible to Adjustment clearly define the formation of the lighVdark limit in the adjustmentunit. Note Secure the plugs after making the adjustment. Set the headlight adjustment unit to For Litronic headlights the ignition must be 10 cm/l0 m (1 %). switched off and on after adjustmentwith the lights switched on. After this, the adjustment 1. First, make the vertical adjustmentof the must be checked again. dipped beam headlights. To do this, line up the lighVdark borderline running upwards at an angle on the right hand side with the dotted 150 line of the adjustmentunit. 03 20 00 Maintenance -GT3 03 -35 Printed in Germany -25, 1999 9960327 ~I