996 Carrera Group 1 – Part 2 Engine / PAGE 260
Engine -Lubrication 911 Carrera (996) · Removing oil temperature sensor -GT3
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
Engine -Lubrication 911 Carrera (996)
Removing oil temperature sensor -GT3
4. Remove oil temperature sensor.
Disconnect electrical connection. Undo and
unscrew oil temperature sensor (aft 22).
'"
061_99
3. Install hydraulicpump.
Place the hydraulic pump with connected lines ~I into installationposition. Tighten the three M8
406_99 fastening screws to 23 Nm (17 ftlb.). Tighten
the M6 screw to 9.7 Nm (7.0 ftlb.). Screw in
Installing oil temperature sensor -GT3 the two fastening screws on the reservoir and
tighten to 23 Nm (17 ftlb.). Tighten the servo1. Install oil temperature sensor.
pump pulleyto 23 Nm (17 ftlb.). Fit drive belt. Fit oil temperature sensor with a new sealing
ring and screw in. Tightening torque 25 Nm
(19 ftlb.). Connect electrical connection.
2. Install air-conditioning compressor.
Push the compressor onto the bracket for
the generator again. Screw in the three
compressor fastening screws and tighten
to 23 Nm (17 ftlb.).
059_99
17 -98 1707 19 Removing and installing oil temperature sensor -GT3
This is a source reference. Confirm exact model applicability in the original material.