Removing coolant pump · No. Procedure Insuuctions

911 Carrera (996) Engine -Cooling Removing coolant pump No. Procedure Insuuctions Drain coolant Undo drain plug at water guide housing and collect coolant. After draining the coolant, fit a new sealing ring on the drain plug. Tightening torque: 10 + 5 Nm (7.5 + 3.5 ftlb.) 2 Clamp shut coolant hoses Clamp shut coolant hoses with hose clamps by Saltus, or- der numbers3093 and 3094. Undo spring-bandclamps with pliers type MUBEAGO-190. 3 + 4 Remove drive belt Removethe complete air cleaner assembly. Mark belt travel direction with a coloured pen. Slacken belt, turning the tensioning pulley(wrench size 24 mm) clockwise, hold still and simultaneouslytake the belt off the drive pulleys. Visuallycheck state of belt and replace if necessary. 5 Support engine-transmissionunit Undo stabilizer.To do this, remove both bearing blocks and disengage stabilizer. Fasten support bridge (special tool 9624/1) at the take-up points of the bearing blocks. Screw in the pressure screw until the pressure disc has contact with the crankcase under slight pressure. 6 Removebracketfor catalytic Undo restraining straps (2 ea.) and hexagon-tleadbolts converter. (2 ea.) and remove bracket. 19 50 19 Removing and installing coolant pump (engine installed) 19 -13