Installation 3.2 Correct position with respect to the wheel · carrier means:1. Install in

911 Carrera (996) Front wheel suspension, drive shafts Installation 3.2 Correct position with respect to the wheel carrier means:1. Install in reverse order. Before installing,give The receiving bore for ~hestabilizer mount in the parts a visual check. Replacebrake the stabilizer block must be centred caliper fastening screws. (aligned)with respect to the cutout of the wheel carrier (arrow).2. Do not grease screwed connectionsin This prevents the stabilizer mount from Dacromet finish -aluminium colour. coming into contact with the wheel carrier Use correct tightening torques. when the wheels are turned completelyto 3.1 Insert spring strut (A) as far as it will go into the right or left. the whee! carrier (B). Before tightening the Note fastening screw No.6, twist (align)the spring strut (A) until the stablizer block is in Contact marks are visible on the housing in the correct position with respect to the individualcases. These mar!ksare due to the wheel carrier (B). incorrectly positioned stablizer block (spring The correct position is described in Point 3.2. strut to wheel carrier). The stabilizer mount is not damaged,however. Note Stabilizer mounts with contact marks can be replaced if assemblyis to be conducted in thisAs the installation conditions are confined,the correct position (fitting) of these parts is a area. prerequisite for adequate clearance of the stabilizer mount in the area of the wheel carrier/stabilizer block. A = Spring strut 40850021 B = Wheelcarrier 4 = Stabilizerblock Arrow = cutout in the wheel carrier (clearance) for the stabilizer mount 40 85 19 Removing and installing front spring strut -GT3 40 -6c Printed in Germany -39, 2000 996406A