Disassembly and assembly instructions · Disassembly Preliminary work and notes on assembly

Disassembly and assembly instructions Disassembly Preliminary work and notes on assembly -Tension the coil spring with the spring clamp Replace nut for fastening the piston rod on until the piston rod is relieved. the spring strut mount. It is recommendedto replace the coil springs only in pairs. I ~'" Note If the coil springs are exchanged,it might be necessaryto use a different spring plate than be- fore. The following spring plates (compensation parts) are available: Allocation of the spring plate according to the coil spring tolerance group (see Page 42 -12). 1 green line = 4.0 mm thick compensationpart. 151 -97 1 white line = 0.5 mm thick compensationpart. To undo the connection between piston rod and spring strut mount: counter at the piston rod with a 7-mm open-endedwrench. Caution: Never use an impact bolter to loosen or tighten the fastening nut. Removeall parts from the pistonrod. Note When installing new parts, observe the allocation according to the Spare Parts Catalogue. 152 -97 42 Disassembling and assembling rear spring strut 42 -11 Printed in Germany, 1997 996427