996 Carrera Group 4 Running Gear / PAGE 71
No. Designation Qty. Removal Installation · 1 Wheel hub 1 Press out wi
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
911 Carrera (996) Rear wheel suspension, drive shafts
Note:
No. Designation Qty. Removal Installation
1 Wheel hub 1 Press out with pressure Press in under a
piece P 297 A under a hydraulic press.
hydraulicpress. For this To do this, place the
purpose, use the separator wheel hub on the wheel
and correspondingshims centring device and
for support press it on the wheel
bearing inner race
using pressure piece
VW 4115A
2 Hexagon-headbolt (10.9) 4 Tighten to 37 Nm
(27 ftlb.)
3 Lid 1 Fit in correct position
(groove down)
4 Wheel bearing 1 Heatwheel bearing housing Heat wheel bearing hou-
to approx. 1000 C sing to approx. 1000 C
(max. 1200 C). (max. 1200 C).
Press out wheel bearing Insert new wheel bearing
with tubular piece in correct position
VW415 A (tool C) (inscriptionfacing the
wheel hub), and then
press again slightly
using,pressure piece
924~/3 (tool D) and
tubul~r piece VW415 A
(tool C)
42 58 19 Removing and installing rear wheel bearing 42 -17
Printed in Germany -21, 1999 9964215
This is a source reference. Confirm exact model applicability in the original material.