Notes on removal and installation · Note Removeretainer plate (lid) (four screws).

Notes on removal and installation Note Removeretainer plate (lid) (four screws). The wheel bearing is removed and installed with Heat wheel bearing housing ~o approx.the wheel bearing housing removed. 1000 C (max. 1200 C). Press out wheel bearing with tubularRemoval piece VW415 A (tool C). -Remove brake disc, parking brake shoes, brake disc cover and speed sensor. Press out rear-wheelhub with pressure piece P 297A (tool A). Use the separator (tool B) for support. If there is not enough space for the wheel hub between the press, appropriate shims will additionallybe necessary. 425_97 Press inner wheel bearing ralce off the wheel hub (Figure 426_97), To do this, use pressure piece P 297A (tool A) in combinationwith the separator (tool B). Note 423_97 First pull the inner bearing race several millimetres off the wheel hub (Figure 741_97) so that the separator can be put into place. For this purpose, use a two-claw puller in combinationwith a suitable pressure piece (e.g. VW433). 42 -18 42 58 19 Removing and installing rear wheel bearing 9964215 Printed in Germany -21, 1999