6. In vehicles with automatic headlightbeam · adjustment, unscrewthe strut from the angle

6. In vehicles with automatic headlightbeam adjustment, unscrewthe strut from the angle sensor (on the left control arm (lower left arm)). Counter with a second open-endedwrench when doing this. 7. Undo stabilizer mount on the stabilizer. Counter with an open-endedwrench when removingfrom the stabilizer mount. 8. Push suitable protection over the drive shaft. Undo the drive shaft on the transmission. 42210004 9. Press drive shaft out of the wheel hub 10. Press off tie rod ball joint on the wheel toothing. I carrier using a commerciallyavailableball joint extractor (tie rod extractor) -refer to Note Workshop EquipmentManual,Chapter2.4, Since the drive shaft can be moved only using No. 113. Whenlooseningthe I,ocknut,hold it great force, iloosenthe shaft inwardswith taps with special tool 9546 (Torx screwdriver). on a copper :mandrel. Raise the shaft in the area of the inner joint (damage to the closure cap of Note the drive shaft possible). Do not damage the boot of the ball joint when For unfavourabletolerances, the drive shaft pressing oft the ball joint. If necessaryI coat the must be pressed out of the wheel hub toothing boot and the ball joint extractor with tyre using a universalwheel hub extractor mounting paste. (Fig. 42210004). V :..I~ 42090001 42 -24 42 52 19 Removing and installing wheel bearing housing (wheel carrier) 9964223 Printed in Germany -33, 1999 ,/