Rear wheel suspension, drive shafts 911 Carrera (996) · Removing and installing right drive shaft (Tiptronic transmissio

Rear wheel suspension, drive shafts 911 Carrera (996) Removing and installing right drive shaft (Tiptronic transmission) Note Note Since the drive shaft can be moved only using The availablespace for drive shaft removal and great force, loosen the shaft inwardswith taps installation varies depending on the transmission on a copper mandrel. Lift up the shaft near the type and the side of the vehicle. The removal inner joint (possible damage to the closure cap and installationdescription is therefore of the drive shaft may occur). subdividedinto: For unfavourabletolerances,the drive shaft must be pressed out of the wheel-hubtoothing Right drive shaft -Tiptronic using a universalwheel-hubextractor. Always check the boots for damage if continuing Left drive shaft -Tiptronic to use the drive shaft! Replacethe boots if necessary. Removing right drive shaft 1. Raise vehicle and remove wheel. 2. Undo axle nut. 3. Slide a suitable protector (e.g. plastic tube, old coolant hose -.0 approx. 30 mm) over the drive shaft. Undo the drive shaft on the transmission flange. 4. Removestabilizer mount on the stabilizer. 5. Remove right spring strut, see 42210004 ServoNo. 42 71 19. 7. Removedrive shaft. To do this, push the drive shaft on the transmissionto the rear and6. Press drive shaft out of the wheel-hubtoothing. upward until the drive toothing can be pulled out of the wheel carrier. Pull shaft out to the front. 42 -38 42 21 19 Removing and installing drive shaft (Tiptronic transmission) 9964231 Printed in Germany -39, 2000