Installation 2. Fit brake pedal and stop light switch. · Tightening sequence o

Installation 2. Fit brake pedal and stop light switch. Tightening sequence of the pedal1. Inspect all bearing bushings X for clutch pedal bearing axle (refer to Fig. 48_98): lever and brake pedal and replace them if No.4 = Pedal bearing axle necessary. Lubricate sliding surfaces of (8...10 Nm (6.0...7.5 ftlb.)) the bearing bushings X and the pedal No.3 = Hexagon nut (10 Nm (7.5 ftlb.)) bearing axle with Optimol, Optitemp LG 2, No.2 = Lock nut for steering outer tube part No. 000.043.203.37. (20 Nm (15 ftlb.)) Note Stop light switch installationand stop light switch adjustment: refer to Repair Group46, "Checkingstop light switch setting", 3. Assemble boost spring, bracket and clutch pedal lever. Description under step 3.1 or 3.2. 3.1 Carrera Mod. '98/ some Mod. '99 3.2 Carrera as of current Mod. '99. Note In the 911 Carrera (996), different boost springs may be fitted. Observeproper allocationwhen replacing the boost spring and/or the bracket. In some cases, a modified (optimised)clutch pedal must also be used when replacing the boost spring. A -Clutch pedal lever 48_98 B -Brake pedal Greasing of the boost spring bearing points isC -Steering outer tube partly necessary and partly not permittedX -Bearing bushings (dependingupon the type of boost spring used). 1 -Retainer 2 -Lock nut Please refer to the Technical Manual-Repair 3 -Hexagon nut Group 3D, Service No. 30 Clutch boost spring:4 -Pedal bearing axle allocationand grease specification.(1...4) -Removal sequence