6911 Targa Body-Equipment, Exterior · Section 7 Glass Roof Panel Center – Folding Rear Window Center

6911 Targa Body-Equipment, Exterior Section 7 Glass Roof Panel Center – Folding Rear Window Center 6_20_02 The glass roof panel (1) is bolted to the frame (2) using M6 tensioning bolts (3) and spacers (4). The bolt locations are concealed by means of caps (5). The upper glass roof panel weatherstrip (6) and the lower weatherstrip (7) is installed in the roof panel frame. The weatherstrip for the folding rear window (9) is installed on the edge of the roof module transverse member (8). The center joint weatherstrip (10) forms a seal between the glass roof panel and the folding rear window. The glass for the folding rear window is bonded to the frame (12) using adhesive (11) around the periphery. The electric motor (13) for the sun screen (14) is attached to the locating frame for the guide tubes (15) for the sun screen drive mechanism. The sun screen is covered by the trim panel (16). The material (17) of the sun screen is pulled out by the guide bow (18) with rubber lip (19) and positioned by the tensioning bow (20). The protective cover (22) is installed on the edge of the trim panel mounting plate (23). 2002 Service Training 6-19