Steering 911 Carrera (996) · Installing steering lock Note

Steering 911 Carrera (996) Installing steering lock Note 1. Fit the steering lock in the vehicle with the If the steering lock cannot be turned to position locking pin in unlocked position (ignition "a", the following causes are possible: steering lock position 1) Slider of keylock cable not correctly fitted Note on the steering lock If necessaryI first modify the lock barrel (use Keylock cable not correctly fitted on theprevious lock barrel) or modify the key head selector console (handheldtransmitter). This makes it unnecessaryto teach the transponder Defective parts (replace if necessary). (refer to Installation, step 11). The keylock cable is not adjustable. However I 2. Align steering lock housing; the peg of the the following procedure (mounting specification) steering lock must engage easily. Tighten must be followed when mounting on the selector fastening screws. console. 3. On Tiptronic vehicles,join the keylock cable Specification for mounting keylock cable on with the steering lock (in steering lock the selector lever position 1). -Turn ignition key to position "I" (ignition on) To do this, line up the slider on the keylock and move selector lever to position "0", cable with the steering lock and insert (press in) in this position until the connection nipple Engage nipple (1) of the cable on the keylock lever (2) of the selector console. engageson the steering lock housing. (Selector lever not in position "P'.) Insert housing adjustmentdevice (3) on the Then select position "P" and subsequentlyturn selector console housing until the clip (4) steering lock to position "0". engages. Press cable sleeve (5) toward the selector console (6). Releasecable and press locking button (7) until it engages. Check keylock function: Insert ignition key to and turn to position 1 (ignition on). Move selector lever from "Poto "0". Turn ignition key counterclockwise. It must not be possible to reach the pull-out position. Then release key again and move selector lever to position "po. In this position, it must be possible to remove the ignition key and the selector 612_~97 lever button must be locked. 48 08 55