996 Carrera Group 2 Fuel, Exhaust, Engine Electronics / PAGE 62
Installation 6. Routethe oxygen sensor cable to the plug · 1. Fasten oxygen sensors w
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
911 Carrera (996) Exhaust system
Installation 6. Routethe oxygen sensor cable to the plug
1. Fasten oxygen sensors with open-endring connectionin the enginecompartment.
wrench. "Black"plug connectionto "black"plug of the
Tighteningtorque 50 -60 Nm (37 -44 ftlb). oxygen sensor.
"Grey"plug connectionto "grey" plug of the
Note oxygen sensor.
(black -in front of catalytic converter) Different values if the suggested tool is used:
(grey -behind catalytic converter)Tighteningtorque 50 Nm (37 ftlb.)
2. Slide a new clamping sleeve onto the
catalytic converter tube.
3. Fit catalytic converter with new seal. Fasten
"three-pointflange".
4. Align clamping sleeve. The position is
designated by embossed arrowheads.The
clamping sleeve is position in the centre
between the arrowheads.Tighten clamping
sleeve. Tighteningtorque 46 Nm (34 ftlb.)
26730003
5. Fastenthe fastening clamp between catalytic
converter and engine carrier.
26 73 20 Removing and installing catalytic converters -engine installed 26 -17
Printed in Germany -38, 1999 9962613
This is a source reference. Confirm exact model applicability in the original material.