Remove catalytic converter of cylinder Installation · bank 1- 3

Remove catalytic converter of cylinder Installation bank 1- 3 1. Fastenoxygen sensors with open-endring wrench. 1. In the engine compartment, pull the oxygen Tighteningtorque 50 -60 Nm (37 -44 ftlb). sensor plug from its holder, unlock and disconnect. Note Differentvalues if the suggested tool is used:2. Unclip cable on engine carrier Tighteningtorque 50 Nm (37 ftlb.) 3. Undo oxygen sensors using a commercially 2. Slide a new clamping sleeve onto the availableopen-endring wrench (wrench size catalytic converter tube. 22). 3. Fit catalytic converter with new seal. FastenNote: "three-pointflange". The oxygen sensor behind the catalytic 4. Align clamping sleeve. The position isconverter must be removed for reasons of designated by embossed arrowheads.Thespace. clamping sleeve is positioned in the centre 4. Loosenthe connectionflange,clamping betweenthe arrowheads.Tighten clamping sleeve. Tighteningtorque 46 Nm (34 ftlb.) sleeveand holdingclampon the enginecarrier. 5. Removecatalyticconverters. 6. Unscrewoxygen sensor in front of catalytic converter. 26730003 5. Fastenthe fastening clamp between catalytic converter and engine carrier. 26 -18 26 73 20 Removing and installing catalytic converters -engine installed 9962613 Printed in Germany -38, 1999