996 Carrera Group 2 Fuel, Exhaust, Engine Electronics / PAGE 80
5. Insert retainingclip. 7. Fit compressor. · Insert the retaining clip into the groove
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
911 Carrera (996) Starter, power supply, cruise control
5. Insert retainingclip. 7. Fit compressor.
Insert the retaining clip into the groove Coatthe spacer sleeve of the rear fastening
provided as shown. Replacethe O-ringon the screw with grease to keep it from falling out.
coolanthose. Lift the compressor back into its installation
position and push on the electrical connection.
8. Fastenthe compressor. Tighten the three com-
pressor fastening screws to 23 Nm (17 ftlb.).
If the throttle body has been turned, it must
be returned to installationposition.
87_99
6. Push on coolant hose.
Align the connection neck of the coolant hose
as shown in the illustration (lug/groove). Press
the coolant hose firmly againstthe connection
neck. The clip must audiblyengage. 061_99
88_99
27 27 19 Removing and installing bracket for generator -GT3 27 -17
Printed in Germany -29, 1999 9962711
This is a source reference. Confirm exact model applicability in the original material.