3. Installationand adjustmentspecificationfor · boost spring bracket.

911 Carrera (996) Clutch, actuation 3. Installationand adjustmentspecificationfor boost spring bracket. Install preassembled boost spring bracket ~""~ with clutch pedal lever. To do this: ~ ", -~-;::?' Step1: ~ Tighten the three fastening nuts (arrows) only 4. 1.+5.slightly (the bracket must still be movable). \I~ JII 2.Step2:Tighten the clutch master cylinder to 10 Nm ~ (7.5 ftlb.) (if the clutch master cylinder was detached). Step3: 32_98 Press the clutch pedal againstthe direction of Notetravel until the pull stop in the clutch master cylinder is reached. The push rod of the clutch save cylinder should not be lubricated in general (for all versions). Step4: Removecotter pin (retaining pin) on the spring 4. Fit new retainer on the pedal bearing axle and cup so that the clutch pedal is pressed against subsequentlysecure the retainer by wedging the rubber stop in the boost spring bracket. it with a mandrel. Step5: 5. Install clutch pedal switch. The bracket is screwed down with the clutch First pull operating plunger out of the switch pedal pressed back (to make full use of the as far as it will go. slots). Tighten hexagon nuts (arrows)in By means of its self-adjustmentfunction, the prescribed sequence. the switch then compensatesfor tolerances Tighteningtorque: 7.5 Nm (5.5 ftlb.). in the pedals. Sequence: 5a / 5b / 5c 30 05 19 Removing and installing the clutch pedal 30 -15 Printed in Germany -18, 1998 996309